COMFORT-AIRE REG-81M Instrukcja Właściciela Pobierz pdf (Strona 6)

Owner’s Manual - RADS-183P, 253P, RAD-283M, REG-183M, 253M

INSTALLATION INSTRUCTIONS

3. Check your storm windows-- if your storm

window frame does not allow the clearance

required, correct by adding a piece of wood as

shown in Fig. E,or by removing storm window

while room air conditioner is being installed.

4 .Check for anything that could block airflow--

check area outside of window for things such as

shrubs, trees, or awnings. Inside, be sure

furniture, drapes, or blinds will not stop proper

airflow.

5.Check the available electrical service- Power

supply must be the same as that shown on the

unit serial nameplate. Power cord is 48 inches

long. Be sure you have an o

utlet near.

6.Carefully unpack air conditioner- Remove all

packing material. Protect floor or carpet from

damage. Two people should be used to move

and install unit.

Preliminary Instructions

A.Window Mounting

Remove Chassis

1. Pull down front grille and remove filter.

(See Fig.1).

2. Lift front grille upwards and place to one side.

3. Locate the four front screws and remove.

These screws will be needed to re-install

the front panel (see Fig.2).

7. Remove shipping screws from top of unit and

also on the side by the base if installed

(see Fig.5).

8. Hold the cabinet while pulling on the base pan

handle, and carefully remove the unit.

9. Add two foam inserts to holes in top of cabinet

where shipping screws were removed.

(see Fig.6).

4. Push metal cabinet side to release plastic tabs

on each side of fr

ont panel (see Fig.3).

5. Gently lift front panel off unit(see Fig.3A).

6. Disconnect the connector plug of the display

panel from the unit and place front panel to one

side(see Fig.4).

Front Grille

Fig.1 Fig.2

Fig.3

Fig.3A

Front Panel

Fig.4

shipping

screws

Fig.5 Fig.6

Tools Required

A large flat blade screwdriver;Tape measure

Adjustable wrench or pliers;Pencil;Level

Socket wrenches;Phillips Screwdriver

Hardware(Packed with the unit)

7/16 inch Locking

screw and Flat

washer for window

panels

3 / 4 £or 1/2)inch

Long Hex-head

Screw

Safety Lock

1 / 2 inch Long

screw and Locknut

3 / 4 inch Long

Flat Head Bolt

and Locknut

Sill Angle

Bracket

Long hex-head

locking screw

for top angle,

side retainer

5 /16 inch Long

2 ea.

4ea.

2ea.

Foam insert

Window sash

seal foam

R1 hardware

(10 *3/4 *1/12 )

NOTE: R1 hardware and Weather stripping is only

for Energy Star models.

Weather stripping

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Komentarze do niniejszej Instrukcji

Brak uwag

COMFORT-AIRE REG-81M Instrukcja Właściciela Strona 6

Komentarze do niniejszej Instrukcji